Creating Right of Way Offsets

Offsets are points whose positions are specified by an offset distance and direction from another point. The offset distance displayed in the Traverse View is negative (-) for left offsets and positive (+) for right offsets.

The offset direction is dependent on the configuration of the point being offset.

TPC has an automatic setback tool

TPC makes it easy to compute offsets through the use of traverses.

Labeling Offset Points

You can determine how the offset points created will be labeled.

Specifying an Offset Tolerance

The offset tolerance determines how close the first and last point being offset need to be in order to be treated like a closed loop. If they do not reference the same survey point but are within the specified tolerance of each other, they will be considered the same point. The figure will close and you will get a single offset instead of two, as shown below.

If the figure you are offsetting is a closed loop, the first and last points are considered to be the same point, so the offset bisects the angle at that point. If they are not considered the same point, each one will have its own perpendicular offset.

Saving Offset Points

As TPC computes the offsets, you can save these points one of two ways as 1) offsets (like sideshots) from their original points or 2) in a new traverse.

Save Offsets as Offset Points

If you choose Save as Offsets, TPC creates an offset point from each point being offset in the current traverse. Offset points get drawn with the side shot settings in Drawing View. You can think of an offset point like a side shot from the point being offset.

Save the Offsets in a New Traverse

If you choose Save as Traverse, TPC creates separate traverses for the left and right points. The created traverse name starts with Left dist followed by the original traverse name for the left offset and Right dist followed by the original traverse name for the right traverse.

Saving the offsets as a traverse creates a figure or boundary along the offset. You will use this option to show setbacks on a lot or right-of-ways along a centerline.

Starting in TPC Desktop 2011, TPC insures that this traverse receives a unique traverse name. It does this by appending a unique number to the traverse name. So for example, multiple offsets from the 'Centerline' traverse will be named 'Centerline1', 'Centerline2', etc.

Creating Offsets for Selected Points

Editions

Personal, Premium, Professional

Related Topics

Using COGO

COGO Commands - reference