|
The curve distances and directions displayed in the Traverse View and the COGO dialogs are based on the distance type of each alignment traverse. For example, if an alignment traverse is formatted for ground distance at project elevation, radii, arc and tangent lengths will be ground distance at project elevation.
This gives you the option of working with alignment parameters at ground (use a ground distance type) or grid (use grid distance type).
Curve and Spiral Definitions
Horizontal curve and spiral definitions are based on grid coordinates. The long chord of a curve or spiral, for example, is a grid line, not a geodesic. The difference between the radial bearings at the beginning and end of a curve or spiral must equal the central/spiral angle and can only do so based on grid bearings and not geodetic bearings. Because of this, TPC does all alignment computations on the grid. Computed values are then factored back to the distance type used in the traverse before they are displayed in the Traverse View.
Mixing Geodetic Tangents with Grid Curves/Spirals
You can use geodetic distance and direction types for an alignment traverse, but you need to consider the inherent issues of mixing geodetic tangent sections with grid curve/spiral definitions.
Foresight Positions
If you create a geodesic alignment and add a foresight with curve or spiral data like radii, arc lengths and central angles, TPC will compute the grid end point of the curve or spiral and report back the geodetic equivalents for chord bearing, chord distance, arc length, etc. You may get a slightly different position for the end point of the curve or spiral if you had entered a geodetic foresight to the end point (created a geodetic tangent first), then added the curve or spiral information like radii and length.
Tangency
You may also find that a tangent course and the curve or spiral that follow it are not exactly tangent. This is generally due to the fact that the Radius Point (PR) at either end of the curve or spiral is computed as a grid point from the curve or spiral end point. At a curve PC for example, the 90 degree offset from the preceding geodetic tangent course may not exactly match the grid bearing inversed between the PC and the PR. This is the source of the non-tangency.
Related Topics
Geodetic Surveys
Editions
Premium, Professional
|