TPC 2026
TPC 2026

 

 

Navigation: <Root level>

Survey Lines

 

 

 

 

As you create traverses, TPC generates the appropriate survey lines from each traverse's point sequence.

As you add points to a traverse, TPC creates the survey lines between those points, whether they be tangents, curves or spirals.  You can see these lines when you draw a traverse and TPC can use them in COGO routines, but TPC does not expose the lines in a manager like it does points and traverses.


Survey Line Rules

TPC has a few simple rules that all survey lines must follow.

Only one line can exist between any two survey points

TPC doesn't allow a tangent, a curve and a spiral to exist between the same two points.  That line has to be one and only one of them.  So when you recall a line between any two points, you get just the one line.

Lines store their curve or spiral information

Each survey line knows whether it is a tangent, curve or spiral and stores its own curve or spiral information.

When you recall that line into a traverse, it comes in with all that information and represents it as clock-wise or counter-clock-wise depending on the direction in which it was recalled.


Recalling an Existing Survey Line

When you insert two points into a traverse, they create create a sequence.  TPC uses this sequence to recall and existing survey line or create a new one.


Storing Survey Lines

Only survey lines with curve or spiral data are stored in the survey (.trv) file. 

Tangent lines are not stored in the survey file.  They are recreated, as needed, by the survey.

 

 

 

 

Copyright © 2026 Traverse PC, Inc.