TPC 2026
TPC 2026

 

 

Navigation: Alignments > Vertical Curves >

Adding Vertical Curves Automatically

 

 

 

 

If your traverse (alignment) already has grade breaks in it, TPC can automatically identify the grade breaks and insert vertical curves with the appropriate lengths. This is typical of road design where you have identified the vertical tangents and are ready to refine the alignment with vertical curves.

•Station your alignment with points at specified intervals for tangents and curves. Only the elevations of existing points will be modified to conform to the vertical curves.

•From the Vertical Curves Screen, choose Edit | Update Vertical PIs.

•Enter the Min Change percent. This is the smallest change in grade that will be considered eligible for a vertical curve.

•Enter up to 5 grade change / curve length combinations. If a grade change equals or exceeds the Change value, the total curve length will be equal to the Length you specify. In the example shown here, a grade change of 7% would get a curve length of 100, while a grade change of 12% would get a curve length of 200.

•Choose OK.

TPC will insert the VPIs into the Vertical Curve Screen and compute all of the curve values. It will not update the traverse. You can choose to update the traverse based on the vertical curve values after you have had a chance to review and/or edit them.

If you don’t specify any Change/Len combinations, the VPIs will still be identified, but no curve data will be inserted - you will need to enter the data for each curve manually.


Related Topics

Vertical Curves

 

 

 

 

 

Copyright © 2026 Traverse PC, Inc.