TPC 2026
TPC 2026

 

 

Navigation: Using GPS / GNSS > Emlid (CSV) >

Connecting via WiFi Hot Spot

 

 

 

 

This topic covers how to connect a mobile device, both providing the hot spot and running emlid flow, to an emlid receiver.  We'll use a Reach 3 here.


Emlid's Documentation

We'll use the Connecting to Reach 3 support page

This page introduces you to the Reach 3's Hot Spot vs Client WiFi modes, but doesn't assist you in selecting them.  We'll cover that here.


The Issue with emlid WiFi Connections

By default, an emlid receiver, like the Reach 3, boots up with it's Hot Spot turned on. In order for emlid flow to communicate with the Reach 3, your mobile device must select the Reach 3's Hot Spot as it's WiFi.

So far so good.  But the Reach 3's Hot Spot does not have internet connection, so you will not be able to receive corrections from your NTRIP network.  To do that, you need to activate the Hot Spot on your mobile device and switch both the Reach 3 and your mobile device to that Hot Spot for WiFi.  This can be difficult to figure out and as of this writing, was not covered in emlid's Support resources.

 


Android Devices

Your goal here is to register your Android devices Hot Spot with the Reach 3.  Once that is don, you can easily switch WiFi networks from emlid Flow.

Here are the steps to connect your Android device (phone) to the Reach 3.

1.Disable other WiFi on your phone.  If they are set to AutoConnect, turn that off, so your WiFi can be on, but does not connect to anything.  Your other option for this step is to get far enough away from your other WiFi sources that none of them connect during this process.

2.Turn on the Reach 3 and select it's WiFi Hot Spot as the receiver in emlid Flow.  

3.If the Reach was previously connected to a different WiFi, you will need to connect with that WiFi again and in emlid Flow choose Receiver, Wi-Fi and choose Activate hotspot.  This tells the Reach 3 to use its own Hot Spot WiFi again.  Back on your phone, go to WiFi settings and select the Reach's WiFi network (Reach3:B9:B8) at PI 192.168.42.1.  The password for this network is emlidreach.

4.Make sure emlid Flow can communicate with the Reach 3.

5.Turn on your phone's Hot Spot.  In emlid Flow choose Receiver, Wi-Fi and select your phone's Hot Spot and enter it's password.

6.On your phone, turn off the WiFi for the Reach 3 Hot Spot or just turn WiFi Off then back On.  Since your phone is providing the Hot Spot, you do not need to select it as the WiFi for you mobile device.  You just need to have WiFi turned on.

7.In emlid Flow, choose Receivers, Refresh.  You should see your receiver with a new Hot Spot IP address, like 192.168.75.206.  Select this receiver.

8.emlid Flow should now be communicating with the Reach 3 and your phone's Hot Spot should be proving NTRIP corrections.

9.To reset the Reach 3 to it's own Hot Spot any time, repeat step 3 above.

 


Related Topics

Using GPS/GNSS
Emlid Flow Introduction
Sharing Emlid Data Without a Hot Spot

Editions

Premium, Professional

 

 

 

Copyright © 2026 Traverse PC, Inc.