TPC 2026
TPC 2026

 

 

Navigation: Drawings > Using Drawing Commands >

Snapping

 

 

 

 

The snap commands allow you to pick an exact position based on other objects in the drawing. The snap options available for any command step are listed in the prompt for that step, as in "Left click start point (End\Mid\Insert\inTersect)".

To do a snap, press the capitalized letter for the snap option you want or select from the Snap toolbar. Move the cursor over the object you want to snap to and left click. If you are snapping to an End, left click near the end you want to snap to. The program uses the computed position of the snap instead of the left click position.


Snap End

Snap to the end point of a line or arc, nearest corner of a rectangle, or nearest vertex of a polyline.


Snap Mid

Snap to the mid point of a line, arc, rectangle side, or polyline segment.


Snap Perpendicular

Snap to a point on this object that is perpendicular to the last node. It can be used with lines and polylines. This snap tool can never be used as the initial insert position of an object.


Snap Insert

Snap to the insert or mid point of the object.


Snap Intersect

Snap to the intersection of two objects.


Snap Nearest

Snaps to the closest object. The cursor must be fairly close to the intended object, usually within ½” or less.

Beginning with TPC Desktop 2026, TPC prompts you to select a near object after you start this command.  Left-click a near object to select it or left-click any blank spot to continue the command without selecting a near object.

Selecting a Near Object

When you select a near object, TPC limits the snap nearest operation to just that object. 

For large drawings, this can greatly increase the responsiveness of this command.

This option is also useful when you want to limit snapping to one particular drawing object.

Not Selecting a Near Object

If you continue this command without selecting a near object, TPC will evaluate the entire drawing to determine the nearest object to snap to.  Much like it does in Object Snap mode.

For large drawings, this may slow down the responsiveness of this command.


Snap Tangent

Snap to a point on an arc or circle that is tangent to the last node. It can be used with lines and polylines. This snap tool can never be used as the initial insert position of an object.


Related Topics

Drawing Commands
Object Snap Mode
Selecting Drawing Objects

Editions

Personal, Premium, Professional

 

 

 

Copyright © 2026 Traverse PC, Inc.