|
TPC computes horizontal offsets from an alignment based on a station along the alignment and the geometry of the alignment at that station.
Offsets are always perpendicular to the alignment except at angle points where the bisect the angle. Because of this, you don't specify an offset direction in TPC. Instead you just specify a distance, negative for left and positive for right, and TPC computes the direction for you base on the alignment. This makes working with offsets very easy in TPC.
Left vs Right
Offsets are considered to be Left or Right, as seen from the direction of the alignment.
Left offsets always have a negative (-) offset distance. Right offset distances are always positive (+).
Offset Elevations
By default, offsets assume the elevations of the alignment points they are created from. However, you can adjust them up or down from their alignment point elevations as seen below in the Right-Of-Way Offset dialog.
Creating Offsets via COGO
COGO tools, like Station Offsets and Right-Of-Way Offsets create OFS points for you.
In this example, we've used the Right-Of-Way Offset tool to create 30 ft offsets from each control point / station in an alignment traverse.

TPC adds an left and right OFS point at each control point / station. Notice that the Left offsets have an L in the point label and a negative Grid Dist.
Note: The ROW Offset routine creates points that are 30 ft left and right of the tangents, this creates offset distances somewhat longer than 30 ft to make the geometry or a bisected angle work.

The OFS points are then drawn as side shots, each originating from it's corresponding control point / station in the traverse. Here, we've specified a green dashed line and labels for the offsets.

Manually Entering An Offset
You can enter offsets in a traverse by specifying the OFS point type. Then enter a + distance for right offsets or - distance for left offsets.
To specify the OFS point type
•select one or more points in a Traverse View
•choose Edit, Point Type, OFS=Offset
Recomputing Offsets
Offset points in a traverse, store just a distance from their corresponding control point / station. The direction of the offset is determined by the alignment geometry at that corresponding control point / station. If the alignment changes, the offset points are recomputed accordingly.
Learning More
Stations and Offsets (23:27) - How to work with your alignments plus other uses for some of the tools.
You'll find more about offsets in the Alignments Learning Guide.
Related Topics
Alignments Station Offsets Right-Of-Way Offsets Alignments Learning Guide
Editions
Premium, Professional
|