TPC 2026
TPC 2026

 

 

Navigation: Calibrating Data > Editing a Calibration >

Calibration Points

 

 

 

 

Calibrations are computed from point pairs that relate Uncalibrated points to their calibrated or target positions.


Control

These are the control points, in the calibrated CRS, that you used to compute the calibration parameters.

Each control point has an Uncalibrated point associated with it.  In the CAL file, these are the From points. If you have 5 Control points, you will have at least 5 From points. The first Control point pairs with the first From point and so on.


Additional Uncalibrated Points

A calibration can also include additional Uncalibrated points.  These additional points do not have a corresponding Control point. However, when the calibration is computed, TPC also computes the calibrated positions and standard errors of these points. You can review these computed standard errors to determine if the error associated with extrapolating the calibration too far outside of the control point area is acceptable or not.


Related Topics

Calibrating Data

Editions

Premium, Professional

 

 

 

Copyright © 2026 Traverse PC, Inc.