TPC 2026
TPC 2026

 

 

Navigation: Checking Closure >

Closure Error Summary

 

 

 

 

TPC computes a number of closing errors including angular, linear, relative, etc. These are reported in the Error Summary section of the Closure View.


Relative Error

Relative error is a measure of the closure of the traverse.  It is reported as both a ratio and a percentage (if the percentage is between 1 and 99).

A relative error report as 1:10000, said 1 in 10 thousand, means that for every 10000 units of traverse length, there is 1 unit of error. 

Expressed as a percent, this would be 0.01% with 1% error equating to a 1:100 relative error, 0.1% equating to 1:1000 and 0.01% equating to 1:10000.  As a rule, TPC places the percent error in parenthesis as in (0.03%).


Linear Error

Linear error is the distance from the computed closing point to the correct closing point.  Horizontal distance is always displayed, but slope distance may also be included.


Coordinate Error

The coordinate errors reported are always the coordinate difference from the computed closing point to the correct closing point.  A coordinate error of 0.5X and 0.3Y would indicate that the correct closing point is 0.5 units east and 0.3 units north of the computed closing point.


Angular Error

Angular error is computed as the difference between a computed bearing and a known bearing supplied by the user (assumed to be the first course for a Closed Loop traverse unless you specify otherwise).


Distance and Direction Types

The Closure View displays data based on the Distance and Direction types selected for that traverse. The types are listed immediately under the Closure View heading at the top.


Distance Units

The distance units displayed in the Closure View are determined by the traverse units.  You set these in the Advanced tab of the Traverse View Format dialog.


Related Topics

Closure View

Editions

Personal, Premium, Professional

 

 

 

Copyright © 2026 Traverse PC, Inc.