TPC 2026
TPC 2026

 

 

Navigation: Alignments > Stations and Offsets > Stationing an Alignment >

Stations dialog

 

 

 

 

Inserts points at specified stations along an existing alignment traverse. You can specify one interval for curves/spirals and another for tangents.

A new alignment traverse is created with the stations in it, leaving the alignment traverse unchanged. The new traverse is inserted into the Traverses Manager immediately below the original alignment.

Tangent

Enter the desired station interval for tangents.

Curve/Spiral

Enter the desired station interval for curves and spirals.

Tolerance

The offset tolerance determines how close any two points being offset need to be in order to be treated as one point. If they do not reference the same survey point but are within the specified tolerance of each other, they will be considered the same point and you will get a single offset instead of two.

Station What

You can select the Entire Traverse or only the Selected Point to compute stations for. If you wish to create stations only for selected points, you must select them in the Traverse View before accessing the Stations dialog.

Compute

Creates the new traverse with the stations and returns you to the previous Traverse View.

Undo

Once you have computed and checked your new stations, you can choose Undo to start over. TPC will remove the new traverse it created and any of the station points it added. The original alignment traverse remains unchanged through both the Compute and the Undo.

Close

Closes this dialog.


Related Topics

Creating Station Offsets
Creating Stations at Intervals
Entering Stations and Equations
Entering Equations
Setting the Default Direction

 

 

 

Copyright © 2026 Traverse PC, Inc.