Automatic leaders are ones that get drawn for you via the Traverse Drawing Settings. You can turn these leaders on for point labels and line labels both.
Automatic Leaders (4:38) - Add leaders automatically to stacked line labels then set the line type, arrow type and gap.
Line / Curve Label Leaders
You turn line label leaders on or off with the [x] Leaders toggle in the Lines section of the Control Point and Side Shot tabs.
You turn curve / spiral label leaders on or off with the [x] Leaders toggle in the Control Point and Side Shot tabs.
Point Label Leaders
You turn point label leaders on or off with the [x] Leaders toggle in the Points section of the Control Point and Side Shot tabs.
Leader Settings
Where ever you have have a [x] Leaders toggle, you also have a [ ] settings button. Select this to change the settings for these automatic leaders.
Drawing vs Traverse Leaders Settings
When you tell TPC to draw leaders using Traverse Drawing Settings, TPC can use the drawing's leader settings for consistency or you can have the traverse use its own settings.