TPC 2026
TPC 2026

 

 

 

 

 

TPC can include radial rays in both a drawing and traverse data reported from the Traverse View.


What are Radial Rays

Radial rays are lines, with bearing and distance, drawn from both the PC and PT of a curve, in the direction of the PR (Point of Radius), but not all the way to the PR.


Radial Ray Data

To include radial ray data in a Traverse View, include the letter c = PC->PR and r = PR->PT in the Traverse View format.  This format is reproduced in reports that include the Traverse View data.


Drawing and Labeling Radial Rays

You include radial rays in a drawing through the Curve/Spiral Settings dialog, specifying whether or not to draw them, and if so, how long to draw them in inches or cm. 


Radial Ray Layer

TPC places these drawing objects on the TPCRadialRays layer.

This allows you to create radial rays for any number of traverses, then either show them in a drawing or not, just by turning the layer On or Off.


Radial Rays Use Side Shot Settings

TPC uses the side shot settings to set the attributes of the radial lines and labels - line type, color and line width for these lines and the format of the labels (above or below the radial lines when aligned and the label order when stacked).  See Label Format Examples.

Radial line direction labels are drawn from the PC or PT to the PR by default, but in the Side Shot settings, you can choose [x] Reverse Labels to draw the direction labels from the PR to the PC or PT.

Some users will want to use the ByLayer settings for the side shot line type, line width and color.  Then they set the values they want for these via the TPCRadialRays layer in the Layers dialog.  TPC makes this step easier by including a [x] ByLayer toggle in the Curve/Spiral dialog.


Using Side Shots for Radial Rays

To include radial rays that draw all the way to the radius and include bearing and distance labels, do the following

•for each curve, create the PR point in the Horizontal Curve dialog

•recall the PR as a side shot from both the PC and PT in the traverse

•use the side shot settings to draw and label the rays


Computing Radial Rays

TPC computes the direction of radial rays by computing the PR (Point of Radius) for the alignment where the ray is generated.  So the same computations that TPC uses for compound curves, reverse curves, tangent to spiral, etc. are used to compute the ray directions.


Related Topics

Alignments
Label Format Examples
 

 

 

 

Copyright © 2026 Traverse PC, Inc.