|
When you use RTK (Real Time Kinematics) for collecting GNSS points, you have one or more base stations, which can be physical or virtual, and RTK vectors to each rover point measured.
TPC treats these RTK base points like occupied points and any RTK rover points derived from then like side shots.
In the Traverse View shown here, the base point 1107 has 5 RTK points measured from it.

Base Point
In the example shown above, the base point 10107, is an NTRIP (RTK Network) base point about 4.5 miles away from the project. Adding a Distance column to the Traverse View would show the distance of each RTK point from the base.
The base point does not contain raw GNSS data like the RTK points do, so those columns are blank, but it does have coordinates and a geodetic position which are stored with the base point in the survey.
Drawing Base Points
When TPC draws base points, it uses the Control / Base settings in the Traverse Drawing Settings.

RTK Points
In the example shown above, the RTK points are the rover measurements made from the base.
Each RTK point has a raw GNSS observation stored with it and the Traverse View can be formatted, as it is in this example, to display that GNSS raw data.
Redundant GNSS Observations
Any traverse can contain additional (redundant) GNSS observations to existing GNSS points. These redundant observations can be use to computed averaged GNSS positions. See Specifying Redundant GNSS Observations.
Drawing RTK Points
When TPC draws RTK points, it uses the Side Shot / RTK settings in the Traverse Drawing Settings.
Related Topics
GNSS Traversing GPS/GNSS Data Specifying Redundant GNSS Observations Traverse Drawing Settings
Editions
Premium, Professional
|