TPC 2026
TPC 2026

 

 

Navigation: Alignments >

Spirals

 

 

 

 

TPC works with spirals much like it works with horizontal curves. You can include spirals in area computations, right-of-way offsets, stationing, etc. There are two basic spiral commands in TPC - the Combination and Single spiral dialogs.


Spirals in Traverses

In TPC, you enter spirals in traverses. The traverse point sequence defines the geometry of the horizontal alignment. Use direction and distance to create the tangents, use incoming and outgoing spiral lengths along with other spiral data to create spirals.

See Alignments Are Defined by Traverses.


Combination Spirals

Combination spirals consist of an incoming spiral, a simple curve, and an outgoing spiral. TPC lets you enter a combination spiral at any PI and takes care of computing and inserting the spirals and curve. Combinations spirals can have different incoming and outgoing spiral lengths. In fact, you can even omit either spiral and just have a spiral - curve or curve - spiral combination.

See Combination Spirals.


Single Spirals

Single spirals consist of a single spiral segment with beginning and ending radii and some length. A radius of zero indicates the flat end of the spiral or the start/end of the spiral.

See Single Spirals.


Spiral Point Types

TPC uses the following point types to identify spiral points:
TS - tangent to spiral (flat end of an incoming spiral)
SC - spiral to curve (sharp end of an incoming spiral)
CS - curve to spiral (sharp end of an outgoing spiral)
ST - spiral to tangent (flat end of an outgoing spiral)

A typical combination spiral might look something like this in the Traverse View.

Point

Type

12TS

TS

12SC

SC

12

PI

12CS

CS

12ST

ST

Notice that TPC uses the original PI point label plus the spiral point types to label the spiral points it creates.


Spiral Data in the Traverse View

The Traverse View will display certain information about the spiral if you turn on the corresponding columns.

Horizontal Distance column (H) - long chord (point-to-point) of the spiral.
Bearing/Azimuth column (B/A) - bearing/azimuth of long chord.
Radius (R) - spiral radius at that point.
Arc length (C) - spiral length.
Delta (Q) - spiral angle.


Grid vs Ground / Geodetic

The spiral distances and directions displayed in the Traverse Veiw and the COGO dialogs are based on the distance type of each alignment traverse. For example, if an alignment traverse is formatted for ground distance at project elevation, radii and spiral lengths will be ground distance at project elevation.

This gives you the option of working with alignment parameters at ground (use a ground distance type) or grid (use grid distance type).

See Geodetic Alignments.


Related Topics

Creating Stations at Intervals
Entering Horizontal Curves
Combination Spirals
Single Spirals

Editions

Personal, Premium, Professional
 

 

 

 

Copyright © 2026 Traverse PC, Inc.