TPC uses the Drawing Codes .BS to begin smoothing and .ES to end smoothing within a traverse.
The codes can be included as a Note or added to point descriptions. See Drawing Codes.
Begin Smoothing at a Point
The drawing code .BS begins smoothing. The point with the code will be smoothed. All points following this code will also be smoothed until the end of the traverse is reached are an .ES code is encountered.
End Smoothing at a Point
The drawing code .ES ends smoothing. The point with the code will not be smoothed. Smoothing will be turned off until a .BS code is encountered.
Clearing Smoothing Codes from a Point
If a point does not have a smoothing code (.BS or .ES) it's smoothing is determined by any previous smoothing codes encountered in the traverse.
Clearing All Smoothing Codes from a Traverse
TPC has a command to remove all smoothing codes from a traverse, or you can remove them manually.
Specify Smoothing in a Traverse View
You can turn smoothing on and off for a traverse in it's Traverse View.
•Select the point at which you want to start or stop smoothing
If the traverse is tagged in the drawing shown in the Drawing View, TPC executes the begin and end smoothing commands as if they were executed fro the drawing, causing the traverse to redraw the traverse with its new smoothing settings.
Specify Smoothing in a Drawing
The Drawing View includes commands to begin smoothing. end smoothing and clear smoothing at any traverse point plus a command to remove all smoothing codes from a traverse.
To execute a smoothing command in the Drawing View
•Right-click the point symbol, point label or end of a line for the point you want to start, end or clear smoothing for.
•From the context menu, choose Traverse Smoothing, then one of the available commands.
•If smoothing has not yet been turned on, TPC will prompt you to do so.
•TPC will redraw the traverse using the smoothing command you just executed.