TPC 2026
TPC 2026

 

 

Navigation: Traverses > Ground Traversing > Carrying Elevations in a Traverse >

Using Benchmarks

 

 

 

 

Benchmarks are points of known elevation. When you take a shot on a benchmark, the elevation of the benchmark along with the target height, slope distance and vertical angle is used to establish the elevation of the instrument’s optics.

In TPC, each occupied point can have one tie to a benchmark. A benchmark does not require a horizontal angle or bearing tie.

Note: The only restriction is that the benchmark point must immediately follow the occupied point or backsight point and cannot follow a sideshot.

If you do not know the elevation of a benchmark, you can always assume an elevation, then enter the correct elevation at a later time and choose Tools | Recompute.

•If the benchmark point already exists, recall it into the Traverse View. If not, create a new point and enter the benchmark elevation.

•Choose Type | Benchmark.

•Enter the slope distance, vertical angle and target height of the shot to the benchmark. The elevation of the instrument optics is computed and stored internally.

The HI for the benchmark point displays the elevation difference between the optics elevation and the elevation of the control point. If the control point elevation and the benchmark elevation are on the same grid, the HI should be close to the measured HI.


Related Topics

Carrying Elevations in a Traverse

Editions

Personal, Premium, Professional

 

 

 

Copyright © 2026 Traverse PC, Inc.